This namespace contains master device interface definitions and is considered authoritative within the ASCOM community.
A collection of rates at which the telescope may be moved about the specified axis by the MoveAxis(TelescopeAxes, Double) method. This is only used if the telescope interface version is 2 or 3
Defines the ICameraV3 Interface
Interface for devices that support one or both of two independent capabilities: Telescope Covers and Flat Field Calibrators.
Defines the IDome Interface
Defines the IFilterWheel Interface
Provides universal access to Focuser drivers - Updated to IFocuserV3 - see remarks below
Defines the IObservingConditions Interface. This interface provides a limited set of values that are useful for astronomical purposes for things such as determining if it is safe to open or operate the observing system, for recording astronomical data or determining refraction corrections.
Describes a range of rates supported by the MoveAxis(TelescopeAxes, Double) method (degrees/per second) These are contained within an IAxisRates collection and serve to describe one or more supported ranges of rates of motion about a mechanical axis. It is possible that the Maximum and Minimum properties will be equal. In this case, the IRate object expresses a single discrete rate. Both the Minimum and Maximum properties are always expressed in units of degrees per second. This is only using for Telescope InterfaceVersions 2 and 3
Defines the IRotatorV3 Interface including new synchronisation methods. In addition cable wrap management is clarified. (see Remarks section below)
Defines the ISafetyMonitor Interface
Defines the ISwitchV2 Interface
Defines the ITelescope Interface
Returns a collection of supported DriveRate values that describe the permissible values of the TrackingRate property for this telescope type.
Defines the IVideo Interface.
Defines the IVideoFrame Interface.
The alignment mode of the mount.
Describes the state of a calibration device
ASCOM Camera status values.
Describes the state of a telescope cover
Well-known telescope tracking rates.
Equatorial coordinate systems used by telescopes. Only used with telescope interface versions 2 and 3
The direction in which the guide-rate motion is to be made.
The pointing state of the mount
Sensor type, identifies the type of colour sensor V2 cameras only
ASCOM Dome ShutterState status values.
The telescope axes Only used with if the telescope interface version is 2 or 3
ASCOM Video Camera supported frame rates.
ASCOM Video Camera status values.